What are anchor bolts made of A stud anchor bolt is a concrete anchor that, once. Wedge anchors look and function like a sleeve anchor but have a much smaller sleeve near the bottom of the anchor. Most anchors are shown as not applicable at or near the mortar joint, I can't really control the location of these anchors. Also Know, what is the strongest concrete anchor Wedge Anchors are extremely popular and are one of the strongest anchors for hold strength. If I go with Hilti they recommend a different anchor for each condition - do you spec both and make the contractor switch back and forth? Powers recommends the same epoxy for both hollow and solid cells, this seems less likely to contractor mix up. Most likely the anchors will hit a mix of solid and hollow cells. I have some questions about how people typically handle the following: These plates will support cantilever tubes so I want to have a good factor of safety in there. The hammer drill will drill the hole easily into the cinder block. Drilling into the solid section does not create many problems when using a masonry bit. an anchor installed in a brick wall would be at least the minimum of our. Subsequently, question is, How do you anchor a cinder block When drilling into a cinder block to place a concrete anchor, a hammer drill must be used with a drill bit that has a carbide tip. I need to attach plates to an existing cmu wall, my loads are in the 400#-600# range per anchor in tension and about 150# shear. and installation of post-installed anchors in concrete and masonry, tests to. I posted this in the fastening group but didn't get any useful tips, maybe someone here has some experience with this:

Hilti anchors in cmu block